How to fix the damaged rubber cable?

How to fix the damaged rubber cable?

How to fix the damaged rubber cable? Rubber sheathed cables are widely used in a variety of electrical equipment, such as mobile power cords for household appliances, electrical machinery, electrical equipment and appliances. It can be used indoors or outdoors. According to the external mechanical force of the cable, the product structure is divided into three categories: light, medium and heavy.

General light rubber sheathed cables are used in daily-use electrical appliances and small-sized electrical appliances, and are required to be soft, lightweight, and have good bending performance;

Medium rubber cable is widely used in agricultural electrification except for industrial use;

Heavy-duty cables are used in applications such as port machinery, searchlights, and large-scale hydraulic irrigation and drainage stations in the home industry. This kind of product has good versatility, complete specifications, good performance and stability.

First, equipment:

Compact pressure device with automatic temperature control, timing and multi-size tubular cavity.

Second, rubber:

It is consistent with the wire used to make up the wire, and contains more glue than the material being filled. The vulcanization system is slightly stronger.

Third, the operation method:

1. Set the temperature and time according to the vulcanization system of the rubber material. 2. Use a rubber ink thinner to wash the repaired area, especially the joint area.

3, according to the size of the gap to cut the amount of repair rubber, pay attention to not too much or too little, 4, will cut the rubber plug in the gap, pay attention to the rubber material is not higher than the wire surface.

5, wrapped with high temperature PP tape. And put it in a tubular mold cavity slightly smaller than the wire diameter, and lock the upper and lower molds, so that the position to be filled with a certain pressure. Note that the cavity diameter is slightly smaller than the wire diameter 0.1~0.2mm.6, until the vulcanization time arrives, take out the product, if there is a small amount of rubber spill, use a sharp blade to complete, and use the thinner to dilute.

Fourth, verification method:

Press the appropriate amount of air into the filled wire and place it in water.

A captive bolt pistol (also variously known as a cattle gun, stunbolt gun, bolt gun, or stunner) is a device used for stunning animals prior to slaughter.

The principle behind captive bolt stunning is a forceful strike on the forehead using a bolt to induce unconsciousness. The bolt may or may not destroy part of the brain.

The bolt consists of a heavy rod made of non-rusting alloys, such as stainless steel. It is held in position inside the barrel of the stunner by means of rubber washers. The bolt is usually not visible in a stunner in good condition. The bolt is actuated by a trigger pull and is propelled forward by compressed air or by the discharge of a blank round ignited by a firing pin. After striking a shallow but forceful blow on the forehead of the animal, spring tension causes the bolt to recoil back into the barrel.


The captive bolt pistols are of three types: penetrating, non-penetrating, and free bolt. The use of penetrating captive bolts has, largely, been discontinued in commercial situations in order to minimize the risk of transmission of disease.

Captive Bolt Stunner Kit

Captive Bolt Stunner Kit,Captive Bolt Stunner Kit Diy,Captive Bolt Stunner Kit Manual

Sichuan Nanshan Powder Actuated Fastening System Co., Ltd. , https://www.nanshanpat.com